TL431 Battery Voltage Monitor

Monitor the voltage of a battery or battery bank using an TL431 (aka LM431) shunt regulator

An TL431 (pictured above) is an Adjustable Precision Zener Shunt Regulator. Its output voltage can be set to any value between 2.5V and 36V with the use of two external resistors (acting as a voltage divider).

With very sharp turn-on characteristics, the TL431 is an excellent alternative to a zener diode in many applications. In this article we will look at how a TL431 can be used to make a very simple battery status monitor.
Click here to view our article on making a battery status monitor with a zener diode.

The full National Semiconductor LM431 Datasheet (PDF) can be viewed by clicking here.
Note that the TL431 is also often labelled as a LM431 and may also be described as a programmable voltage reference.

Using the TL431

The TL431 is most commonly found in the TO-92 packaging pictured at the start of the article - a piece of black plastic out of which emerge three legs. Below the connections are labelled - REF
is the voltage reference.

..and here below is shown the way the TL431 is represented in circuit diagrams

TL431s can be purchased cheaply from almost any stockist of electronic components worldwide. We also have them available for sale in the REUK Shop.

TL431 Voltage Monitor Circuit

Above is shown the circuit diagram for this TL431-based voltage monitor. The aim of the monitor is simply to light up an LED when a target voltage is reached - perfect for a solar battery charger to let you know when the batteries have reached full charge.

The simple equation displayed above gives the high limit - in this case the voltage at which the LED will light up. Since the reference voltage (Vref) is fixed at 2.5 Volts in the TL431, the two resistors are simply selected to provide the desired result.

For example, if you require the LED to light up when the input voltage reaches 7 volts, R1 could be set to 1K8 (1,800 Ohms) and R2 to 1K. Multiplying 2.5 by (1+ (1800/1000)) gives 7.0 Volts exactly as required.

Ideally the R1 and R2 resistors used should both be well over 1K Ohm to ensure that the reference input current stays below its 10mA safe use limit.

The resistor labelled R4 in parallel with the LED prevents the LED from glowing softly when the input voltage is still below the switch-on voltage. We used a 1K Ohm resistor in our experiments successfully. (The lower the resistance value used for R4 for sharper the switch-on

The R3 resistor is there to protect the LED from excessive current - we used a 500 Ohm resistor, but the value selected depends on the specification of the LED used and the brightness required.
- i.e. a tiny increase in voltage causes the LED to suddenly light up brightly)

Read More

what diode and how to use

diode is basically semi conductor device it' use a.c and d.c when it's use a.c it's work as switch means during positive cycle it's on and  when negative circle come it's diode is off    when d.c  use diode work as short  circuit means diode never off .  when a.c single pass then his out put pulsating  d.c value is greater then a.c value because.                                                                                                                                                                      D.C=1.414A.C SO PULSATING D.C OUT OUT GREATER THEN A.C VOLTAGE and when d.c input use his out put d.c voltage is less the d.c input voltage because some voltage drop across the diode.

diode also uses flow of current forward direction.in diode flow of current always opposite direction flow of electron. 

                                                                                                                                                               

                                                                             

Read More